2.7
“Previous
destinations”
This menu enables you to select
a destination from the list of ad-
dresses last used. These are au-
tomatically stored.
From the “Navigation” menu:
– select “Destination” then
“Previous destinations”.
– From the list of stored destina-
tions, select an address to start
navigating.
“Points of interest”
A point of interest (POI) is a serv-
ice, establishment or even a tour-
ist area close to a location (start
point, destination city, en route,
etc.).
Points of Interest are listed by cat-
egory: restaurants, museums, car
parks, etc.
Select “Destination” from the
“Navigation” menu, then “Points
of interest” to select a destination
from the points of interest.
“Name search”
A list is displayed in which you
can consult all POIs found
along the route (if there are
any) or around your current po-
sition. You can filter the list of
POIs using the keypad. Select
a POI from the list of results or
enter the name/type of POI that
you want to look for using the
keypad.
ENTERING A DESTINATION (2/6)
For safety reasons, carry
out these operations when
the vehicle is stationary.
“Location search”
This function enables you to
search for POIs in a town/city
or along a route, by selecting a
point of interest from a list or by
typing it using the keypad.
Select the search area from
among the following catego-
ries:
– “In a city”;
– “Nearby“;
– “Along Route” (if there are
any);
– “Near destination” (if there
are any).
After selecting a search area,
the screen displays the POIs
available by category (“All”,
“Airport”, “Automobile”, etc.).
Select a category.
All POIs in this category are
displayed in a search area.
Select the desired POI to start
guidance.
To Next Page
Loading...
