Renesas RL78 - TAU0 Channel 3 Operation Stop Function

RL78/G11 UART Reception in STOP Mode Using Middle-speed On-chip Oscillator IAR
R01AN3634EJ0100 Rev.1.00 Page 77 of 85
Feb. 15, 2017
5.9.17 TAU0 channel 3 operation stop function
Figure5.22 shows the flowchart for TAU0 channel 3 operation stop function.
Figure 5.22 TAU0 Channel 3 Operation Stop Function
・Timer channel stop register 0 (TT0)
Set to TAU0 operation stop.
TAU0 Channel 3 O
p
eration Disable
Symbol: TT0
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 0 0 0 TTH
03
0 TTH
01
0 0 0 0 0 TT0
3
TT0
2
TT0
1
TT0
0
x x x x x x x x x x x x 1 x x x
Bit 3
TT
03
Operation stop trigger for channel n
0 Clears TEmn bit to 0 and goes to count operation stop state.
1 Operation stopped (stop trigger generated)