Renesas RZ Series

RZ/G, RZ/V
Series
RZ Family / RZ/G, RZ/A Series 2. Functional Specifications
R01UH0990EJ0101 Rev.1.01 Page 29 of 83
Jul 28, 2022
Table 2.2 List of Pin Function Selection Used on Each Module Board (5/18)
Pin
Location
Pin Name
RZ/G2UL
Pin Function
RZ/A3UL
Pin Function
RZ/Five
Pin Function
Description
SMARC
Pin No.
SMARC
Pin Name
A3
OM_SIO5
NC
OM_SIO5
P24_3
OctaFlash (IC2) and OctaRAM (IC3)
Note: Unused in case of
RZ/G2UL
—
—
B3
OM_SIO6
NC
OM_SIO6
P24_4
OctaFlash (IC2) and OctaRAM (IC3)
Note: Unused in case of
RZ/G2UL
—
—
A2
OM_SIO7
NC
OM_SIO7
P24_5
OctaFlash (IC2) and OctaRAM (IC3)
Note: Unused in case of
RZ/G2UL
—
—
F14
OTP_VDD18
OTP_VDD18
OTP_VDD18
NC
1.8V
Note: Unused in case of
RZ/Five
—
—
B1
P0_0/SD0_CD/
RIIC3_SDA/
MTIOC2A/
SCI0_TXD
P0_0/SD0_CD
P0_0/SD0_CD
P0_0/SD0_CD
Card Detection
High: No card, Low: Card insertd
Connected to microSD card slot
(CN3) for SD0
Note: Only available
when SW_SD0_DEV
_SEL(SW1-2) is
disabled else this is
used for GPIO0
P108
GPIO0
C2
P0_1/SD0_WP/
RIIC3_SCL/
MTIOC2B/
SCI0_RXD
P0_1
P0_1
P0_1
Carrier Board Connector, connected
to 24pin FFC/FPC connector for
MIPI-CSI (CN1), used as
CAM1_RST#
P111
GPIO3
D3
P0_2/SD1_CD/
MTIOC1A/
RIIC2_SDA/IRQ0
SD1_CD
SD1_CD
SD1_CD
Card Detection
High: No card, Low: Card inserted
Carrier Board Connector, connected
to microSD card slot (CN10) for SD1
P35
SDIO_
CD#
C3
P0_3/SD1_WP/
MTIOC1B/
RIIC2_SCL/IRQ1
P0_3
P0_3
P0_3
Enables power to the uSD Card
Carrier Board Connector, connected
to microSD card slot (CN10) for SD1
Driven from the Reset signal due to
limited SoC IO
P37
SDIO_
PWR_EN
P1
P4_5/
ET0_LINKSTA/
MTIOC3D
P4_5/
ET0_LINKSTA
P4_5/
ET0_LINKSTA
P4_5/
ET0_LINKSTA
Ethernet PHY_0 (IC22)
Carrier Board Connector, connected
to PMOD1 connector (J2)
P119
GPIO11
T3
P4_3/ET0_MDC/
RSPI1_SSL/
MTIOC8D/
MTIOC3B
RSPI1_SSL/
ET0_MDC
RSPI1_SSL/
ET0_MDC
RSPI1_SSL/
ET0_MDC
Ethernet PHY_0 (IC22)
Carrier Board Connector, connected
to PMOD0 connector (J1)
P54
SPI_CS0#
T2
P4_4/ET0_MDIO/
MTIOC3C
P4_4/ET0_MDIO
P4_4/ET0_MDIO
P4_4/ET0_MDIO
Ethernet PHY_0 (IC22)
Carrier Board Connector, connected
to 24pin FFC/FPC connector for
MIPI-CSI (CN1), used as
CAM1_PWR#
P109
GPIO1
N1
P3_1/
ET0_RX_CTL/
RX_DV/
SSI1_RCK/
POE4#/MTIOC0B
SSI1_RCK/
ET0_RX_CTL/
RX_DV
SSI1_RCK/
ET0_RX_CTL/
RX_DV
SSI1_RCK/
ET0_RX_CTL/
RX_DV
Ethernet PHY_0 (IC22)
Carrier Board Connector, connected
to PMOD0 connector (J1)
S39
I2S0_LRCK