Renesas RZ/T2M

Renesas Starter Kit+ for RZ/T2M 1. Overview
R20UT4939EG0100 Rev. 1.00 Page 10 of 87
Apr 20, 2022
1.3 Board specification
Board specification is shown in Table 1-1 below.
Table 1-1: Board Specification
Item
Specification
Microprocessor
Part No: R9A07G075M24GBG
Package: 320-pin FBGA
On-Chip Memory: RAM 2MB
On-Board Memory
SDRAM: 256Mbit (Data width 16bit)
*1
NOR Flash: 256Mbit (Data width 16bit)
Octa Flash: 512Mbit
HyperRAM: 64Mbit
QSPI Serial Flash: 512Mbit
I
2
C EEPROM: 16Kbit
Input Clock
RZ/T2M Main: 25MHz
RL78/G1C Main: 12MHz
Ethernet PHY (for RGMII): 25MHz
Power Supply
DC Power Jack: 5 V Input
USB Type-C Connector: 5V Input
Power Supply IC: 5V Input, 3.3V Output
Power Supply IC: 5V Input, 1.8V Output
Power Supply IC: 5V Input, 1.1V Output
Power Supply IC: 5V Input, 1.0V Output (For Ethernet PHY)
Power Supply IC: 5V Input, 2.5V Output (For Ethernet PHY)
Debug Interface
MIPI-10: 1.27mm pitch 10-pin header
MIPI-20: 1.27mm pitch 20-pin header
Mictor-38: 0.64mm pitch 38-pin header
J-Link
®
OB: USB-MicroB
DIP Switch
Mode Configuration: 10-pole x 1
Signal Select: 10-pole x 2
User: 8-pole x 1
Push Switch
Reset Switch x 1
User Switch x 3
Potentiometer (for ADC)
Single-turn, 10kΩ
LED
3.3V Power Indicator: green x 1
User: green x 1, yellow x 1, red x 2
Ethernet Status: green x 3, yellow x 3
Ether-CAT Status: green x 4, yellow green x 1, red x 3
J-Link
®
OB Status: yellow x 1
Ethernet
Connector: RJ45 x 3
PHY: Single Port PHY x 3
CAN
*2
Connector
*3
: 2.54mm pitch, 3-pin x 1
CAN Driver x 1
USB
USB-Function: Mini-USB
USB-Host: USB-Type A
RS485
Connector
*3
: 10-pin Connector
RS485 Transceiver x 1
USB to Serial Converter Interface
Connector: Mini-USB
Driver: RL78/G1C Microcontroller (Part No R5F10JBCAFP)
Pmod™
PMOD-2A, 6A: 12-pin Connector
PMOD-3A: 12-pin Connector
mikroBUS™
2.54 mm pitch, 8-pin x 2 (J21, J22)
Grove
®
2.00 mm pitch, 4-pin x 2 (J27, J28)
QWIIC
®
1.00 mm pitch, 4-pin x 1 (J30)
Pin Header
*3
2.54 mm pitch, 20-pin x 2 (CN1, CN3), 2.54mm pitch, 8-pin x 1 (CN2)
Application Board Interface
*3
2.54 mm pitch, 26-pin x 2 (JA1, JA2), 50-pin x 1 (JA3), 24-pin x 2 (JA5, JA6)
*1
: Access frequency of SRAM is up to 50MHz on this board.
*2
: The CAN on this board can transfer at up to 5Mbps.
*3
: This part is not mounted.