Renesas Starter Kit+ for RZ/T2M 6. Configuration
R20UT4939EG0100 Rev. 1.00 Page 33 of 87
Apr 20, 2022
6.2.4 Traditional Pin Header Jumpers
These jumpers are traditional small pitch jumpers that require an external shunt to open/close them. The
following table describes the default settings for traditional pin header jumpers on the CPU board.
Table 6-2: Default Pin Header Jumper Settings
When using QSPI Serial Flash
When using VCC1833_2 domain at 3.3V
When using VCC1833_2 domain at 1.8V
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using the RS485 transmission method in full duplex
When using the RS485 transmission method in half duplex
When using the RS485 transmission method in full duplex
When using the RS485 transmission method in half duplex
When using the J-Link
®
OB
When using the external emulator or not using the emulator
To Next Page
Loading...
Need help?
General
