Renishaw NC4 Installation And Maintenance Guide

31Installation – NCi-4 interface
Introduction
The NCi-4 interface should be installed in the
CNC control cabinet. Where possible, locate the
unit away from potential sources of interference
such as transformers and motor controllers.
The interface processes signals from the NC4
and converts them into a voltage-free solid state
relay (SSR) output. This is transmitted to the
CNC machine control, which responds to the
probe inputs.
Installing the interface
WARNING: Before installing the NCi-4
interface, ensure the machine is safe to
work on. Switch off machine power when working
in the control cabinet.
Install and configure the NCi-4 interface as
described in the publication “NCi-4 installation
and user’s guide”, Renishaw part no.
H-2000-5236.
!

Renishaw NC4 Specifications

General

Brand	Renishaw
Model	NC4
Category	Tools
Language	English