30
17. Remove the blanking plugs and straight
adapters from the ends of the air pipes.
Connect the air pipes to the outlet of the air
filter / regulator unit using the tee fittings
and pneumatic adaptor fittings as
appropriate.
18. Fit conduit clamps to secure the conduit in
position on the table of the machine. This
will ensure that loads are not transferred to
the NC4 system when the machine operates
(see the figure on page 23).
Installation – separate system
What to do next
After you have finished installing the NC4
separate system you should install the NCi-4
interface.
To Next Page
Loading...
Need help?
General
