3
Safety instructions for the user
IMPORTANT!
READ CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE!
This description contains the information required for correct use of the products described in it. It is
intended for technically qualified personnel.
Qualified personnel are persons who, because of their training, experience and instruction, as well as
their knowledge of applicable standards, regulations, health and safety requirements and operating
conditions, have been authorized by those responsible for the safety of the equipment to carry out
required activities at any time, and who can recognize and avoid possible hazards in the course of these
activities (definition of qualified employees according to IEC 364).
General safety instructions
The following instructions are provided for the personal safety of operating staff and also for the safety of
the products described and connected equipment.
Hazardous voltage
Non-observance can result in serious or fatal injury as well as material damage.
- Isolate from the mains before installation or dismantling work, as well for
post-installation modifications.
- Observe the accident prevention and safety rules applicable for the specific
application
- Before putting into operation, check if the rated voltage for the unit conforms with
the local mains supply voltage.
Electric shock in the absence of earthing
If the protective earth connection of devices with protection class I is missing or
incorrectly executed, high voltages may be applied to exposed parts and the housing
which, if touched, can result in serious or fatal injury.
- Ground the unit correctly.
Electric shock in case of damaged equipment
Improper handling may result in damage to equipment. If units are damaged, dangerous
voltages may be present on the housing or on exposed components which, if touched,
can result in serious or fatal injury.
- During transport, storage and operation, observe the limit values specified in the
technical data.
- Do not use damaged equipment.
To Next Page
Loading...