REPLIGEN KrosFlo ACSS-60K

KrosFlo® TFF System – Auxiliary Scale ACSS-60K
User Guide
22
repligen.com 420-14871-002 Rev. 00
11.1 Running working mode
1. Go to the home screen, press key, name of the first available working mode is
displayed.
2. Press key, names of available working modes are displayed successively one by one.
3. Enter selected working mode, by pressing key to confirm.
Note: The weighing device program has been designed to make the scale run, upon restart, with the
latest operated working mode on.
11.2 Working mode local settings
Each working mode features specific (local) functions which enable customize scale operation. To go
to local settings of each working mode, enter <P3.Func> submenu. Some special functions are
available for all working modes, refer to the table below:
Table 10. Working mode settings
Accessibility Save mode Time interval Lo threshold
Weighing
3.1.1.Acc
3.1.2.Snn
3.1.3.Int
3.1.4.Lo
Parts Counting
3.2.1.Acc
3.2.3.Snn
3.2.4.Int
3.2.5.Lo
+/- control
3.3.1.Acc
3.3.2.Snn
3.3.3.Int
3.3.4.Lo
Percent Weighing %
3.4.1.Acc
3.4.3.Snn
3.4.4.Int
3.4.5.Lo
Peak Hold
3.5.1.Acc
-
-
3.5.2.Lo
Totalizing
3.6.1.Acc
3.6.2.Snn
3.6.3.Int
3.6.4.Lo
Animal Weighing
3.7.1.Acc
-
-
3.7.3.Lo
11.2.1 Working mode accessibility
To enable/disable given working mode, press key.
1. Enter <P3.Func> menu and select a given working mode.
2. Go to <Acc> function.
3. Press key, parameter values are displayed successively one by one, where: YES –
working mode enabled, no – working mode disabled.
4. Press key to confirm, next return to home screen.
11.2.2 Save mode
Parameter allowing to set mode of sending data from the weighing device to a peripheral device.
1. Enter <P3.Func> menu and select a given working mode.
2. Go to <Snn> function
3. Press key, parameter values are displayed successively one by one, where: