KrosFlo® TFF System – Auxiliary Scale ACSS-60K
repligen.com 420-14871-002 Rev. 00
Table 17. Totalizing – Local settings
Submenu Setting
Working mode accessibility
17.2 Totalizing operation
1. Enter <Add> working mode (Totalizing), blinking “▲” pictogram is displayed.
2. If the ingredients are to be weighed in a container, first put the container on a weighing pan
and tare it.
3. Load the weighing pan with the ingredient no. 1. When the indications are stable (
pictogram is displayed), press key to confirm the mass.
4. Unload the weighing pan, ZERO is displayed, “▲” marker starts blinking again.
5. Load the weighing pan with the ingredient no.2, wait for a stable weighing result and press
key.
6. Total mass value of ingredient no. 1 and 2 is displayed, now the “▲” pictogram is displayed
continuously.
7. In order to finish the process, press key, text <Prnt?> (Print?) is displayed.
8. Press key, total mass value of all recorded weighings is printed on a scale-connected
printer.
Figure 12. Totalizing printout example
9. In order to print the report once again press key.
10. To exit “report printout mode” press key. As a result, the home screen of <Add>
working mode is displayed and all the data get zeroed automatically.
Note: If the display capacity is exceeded (i.e. there is not enough space for all the digits of the
weighing result) <Hi> error is displayed. In such a case either remove the ingredient from a
weighing pan and finish the totalizing process or place load of a lower weight value on the
weighing pan.
To Next Page
Loading...
