REPLIGEN KrosFlo ACSS-60K

KrosFlo® TFF System – Auxiliary Scale ACSS-60K
User Guide
25
repligen.com 420-14871-002 Rev. 00
4. Select respective option and press key to confirm, first, text <LoAd> is displayed for 1
second, next you see a weighing window.
5. If the parts are to be weighed in a container, first put the container on a weighing pan and
tare it.
6. Load the weighing pan with the declared amount of parts. When the indication is stable (
pictogram is displayed), press key to confirm the mass.
7. Single part mass is calculated automatically, the quantity of parts (pcs) is displayed.
Note: Total weight value of all parts loaded onto the weighing pan cannot be greater than the max
capacity value.
Note: Single part mass value must be equal or greater than 0.1 of the reading unit. Unless this
condition is met, the weighing device displays a message <ErrLo>.
Note: In the course of parts quantity determination it is necessary to wait for a stable measurement
before confirming the declared quantity value.
14. Working mode - +/- control
+/- control is working mode enabling to enter checkweighing threshold values (Min, Max).
14.1 Local settings
To go to local settings, enter <3.3.HiLo> submenu.
Table 14. +/- control – Local settings
Submenu Setting
3.3.1.Acc
Working mode accessibility
3.3.2.Snn
Save mode
3.3.3.Int
Time interval
3.3.4.Lo
Lo threshold
14.2 Declaring checkweighing thresholds
1. Enter <HiLo> working mode (+/- control), first, text <SEt Lo> is displayed for 1 s, next you see
a window for declaring low weighing threshold (Min).
2. Enter a respective value and press key to confirm, first, text <SEt Hi> is displayed for 1
second, next you see a window for declaring high weighing threshold (Max).
3. Enter respective value and press key for confirmation, working modes home screen is
displayed along with the declared threshold value, where: Min – Load mass lower than low
weighing thresholds, Ok – Load mass within weighing thresholds, Max – Load mass greater
than high weighing threshold.
Note: If the entered low threshold value (Min) is greater than the high threshold value (Max), <Err
Lo> error is displayed.