KrosFlo® TFF System – Auxiliary Scale ACSS-60K
repligen.com 420-14871-002 Rev. 00
18. Working mode – Animal Weighing
Animal Weighing is a working mode enabling to weigh products that disrupt efficient establishing of
stability. It is mostly intended to measure weight of animals.
18.1 Local settings
To go to local settings, enter <3.7.AnLS> submenu.
Table 18. Animal Weighing – Local settings
Submenu Setting
Working mode accessibility
18.2 Animal Weighing operation
1. Enter <AnLs> working mode (Animal Weighing).
2. First, text <tinnE> is displayed for 1s, next you see a window for setting duration (in seconds)
of animal weighing.
3. Press key, parameter values are displayed successively one by one, where: 5[s], 10[s],
20[s], 30[s], 40[s], 50[s], 60[s].
4. Set the respective value, press key to confirm, weighing result window with A letter is
displayed.
5. Load the weighing pan with an animal.
6. On exceeding the set mass value of <Lo threshold> parameter, animal weighing starts, this is
signaled with display of ‘dash’ <- >.
7. Upon process completion, mass value of an animal is snapped and displayed together with
OK pictogram in the upper part of the display. The snapped mass value is sent to a scale-
connected printer.
8. Press key to restart animal weighing.
9. Press key to reprint the snapped mass value.
10. Upon unloading of the weighing platform, the weighing result window with letter A is
displayed. The scale can be loaded with an animal again.
19. Maintenance
In order to ensure safety in the course of cleaning, it is necessary to disconnect the device from the
mains. With this condition met, uninstall the weighing pan and other detachable scale components.
Note: Cleaning the weighing pan while still installed may cause damage of the measuring system.
19.1 Cleaning ABS components
To clean dry surfaces and avoid smudging, use clean non-coloring cloths made of cellulose or cotton.
You can use a solution of water and detergent (soap, dishwashing detergent, glass cleaner). Gently
rub the cleaned surface and let it dry. Repeat cleaning process if needed.
To Next Page
Loading...
