DOC0304 eRev. [Major Version]1.01.0 [Publica
© 2023 Repligen Corporation. All rights reserved. The trademarks mentioned herein
are the property of Repligen Corporation and/or its affiliate(s) or their respective owners.
KrosFlo® KR2i Real-Time Process Management (RPM™) System
Customer Service
Repligen Corporation
685 Route 202/206
Bridgewater, NJ 08807
analytics-support@repligen.com
(908) 707-1009
14. Index
alarm .................................................. 15, 19, 20, 40
auxiliary pump .............. 6, 15, 17, 18, 19, 37, 38, 44
backpressure valve............................... 6, 15, 38, 44
C. Mode ................................................................ 16
C/D Mode ............................................................. 16
C/D/C Mode ......................................................... 16
C/D/D/C Mode ..................................................... 17
Calibration ............................................................ 20
Cary 60 ..................................................... 13, 29, 30
caution ............................................................. 7, 25
CF/D/C .................................................................. 19
CFC ....................................................................... 18
Concentration .......................................... 15, 16, 41
Conductivity ....................................... 39, 40, 43, 44
Diafiltration ........................................ 15, 18, 40, 41
flow cell .............................................. 35, 36, 39, 46
FlowVPX ...... 6, 13, 14, 15, 26, 28, 29, 31, 32, 33, 46
hardware setup ..... 15, 16, 17, 18, 19, 21, 26, 37, 39
KONDUiT ............................................ 13, 39, 40, 44
KR Jr ................................................... 13, 37, 38, 44
KR1 ................................................................. 37, 44
KrosFlo RPM Software .................... 6, 13, 19, 34, 36
note 7, 15, 16, 18, 19, 20, 23, 24, 29, 32, 38, 39, 40
octopus cable .................... 13, 15, 37, 38, 39, 43, 46
part number ............................................. 14, 44, 46
precautions ................................. 7, 8, 21, 23, 25, 31
process mode ...................................................... 15
RPM mode ........................................................... 20
safety ............................................................... 8, 19
SAW scale ............................................................ 37
shear rate ............................................................. 41
specifications ............................................. 9, 10, 12
UV ........................................... 14, 19, 39, 40, 43, 44
VPT ................................................ 33, 34, 35, 36, 41
warning ............................................. 7, 8, 21, 23, 31
To Previous Page
Loading...
