d. One More Data Point: Allows the user to take a data point that was not part of the data
collection intervals
e. Start Collection: Starts collecting data. Please note that during data collection, KF Comm is
unable to record data if the user is actively navigating through the Add-ins tab and its menus
(other than the Pump Control) or if the user is inside a cell in Excel. SpectrumLabs.com
recommends that the data collection computer be designated for data collection only when
running a process. Concurrent activities on the computer may interrupt or disable KF
Comm's ability to collect data properly
f. Hardware Settings: Access and change the TFF system's basic hardware setting
g. Workbook License: Calls up a dialog with licensing information
h. About KF Comm: Calls up a dialog with basic KF Comm information
11.6 Worksheets Overview
a. Integrity Test: Collect data with this worksheet during integrity testing to ensure membrane
integrity
b. Module Characteristics: Collect data with this worksheet when analyzing initial water flux
c. Header: Contains information that is used to populate the Header of the Trial Data
worksheet; fill out information in either the Header worksheet or the Header section of the
Trial Data worksheet
d. Trial Data: Collect data with this worksheet when running application
e. Graph Worksheets: There are a number of other worksheets in the workbook template that
are automatically populated with information from the three data collection worksheets.
These graphs are:
i. NWP
ii. Pressures and CF vs Time
iii. Pressures and CF vs VT
iv. Flux Rate vs Time
v. Flux vs CF
vi. Feed Flow Rate vs Time
vii. DV/Cond vs Time
viii. UV vs Time
To Next Page
Loading...
Need help?
General
