7.2 Manual Mode Setup
NOTE: Valves are intentionally left out of the diagrams below for visual clarity.
1. Any combination of Auxiliary Components is possible in Manual Mode—the only required
component is the TFF system pump itself. Diagram above is a full setup with all Auxiliary
Components
2. Auxiliary Pumps
a. Connect up to two auxiliary pumps to the Auxiliary Component Cable’s “Auxiliary
Pump 1” and/or “Auxiliary Pump 2” ports
b. Connect auxiliary pump power cable(s)
3. Auxiliary Scales
a. Connect up to two scales to the Auxiliary Component Cable’s “Feed Scale” and/or
“Permeate Scale” ports
To Next Page
Loading...
