Resol DL2 - SD Memory Card Slot; Power Supply Connection; Vbus Connection; 5 Accessing the DL2 Datalogger over the Internet with the Vbus.net Visualisation Portal

10
Installation Conguration Data export / CongurationWeb-Interface Eliminating errorsIndications
en
4.5 SD memory card slot

The SD memory card slot  is located at the left-hand side of the device. By means
of the SD memory card slot, data logged can be transferred onto an SD or SDHC
card of up to 8 GB memory capacity.
Note
The memory of an SD card in the slot is used for data transfer only. It will
not enlarge the memory of the DL2 Datalogger.
4.6 Power supply connection
Power supply is carried out via a pre-connected mains adapter. The connection
terminals are located inside the housing of the DL2 Datalogger.
4.7 VBus
®
connection
The DL2 Datalogger is to be connected to the controller via the pre-connected
VBus
®
cable. The connection terminals are located inside the housing of the DL2
Datalogger.
5 Accessing the DL2 Datalogger over the Internet
with the VBus.net visualisation portal
The Datalogger DL2 can be easily connected to VBus.net.
www
Note
In order to enable VBus.net access, the Datalogger must have uncondition-
al access to the ports 80 and 1194 / 1195.
In order to access a DL2 Datalogger delivered with the rmware version 2.0.0 or
higher via VBus.net, proceed as follows:
1. Enter VBus.net into the address bar of the browser and click Sign up.
2. Wait for the conrmation e-mail to arrive.
3. Click Add new device.
4. Enter the alphanumeric 8-10-digit code (Access Token, see label).
If you do not have a token label, proceed as follows:
1. Activate VBus.net in the DL2, if necessary.
2. In the main menu DeviceCong, select the submenu Remote Access.
3. Note down the alphanumeric 8-10-digit code (Access Token) indicated on the
Remote access over Internet tab.
4. Enter VBus.net into the address bar of the browser and click Sign up.
5. Wait for the conrmation e-mail to arrive.
6. Click Add new device.
7. Enter the alphanumeric 8-10-digit code (Access Token)
In order to access the DL2 Datalogger over the Internet without VBus.net, see chap.
9.1 Accessing the DL2 Datalogger over the Internet without VBus.net,
page 18.