Resol DL2 - 9.4 Network Configuration; Data Display Configuration

20
Installation Conguration Data export / CongurationWeb-Interface Eliminating errorsIndications
en
The data can be displayed as follows:
• In a schematic drawing of the system in which sensor data are assigned to the
components.
• In a tabular overview (factory setting).
In order to reduce the data trafc from the local network to the Internet, the
background drawing of the system can optionally be stored on an Internet server.
Requirementsforthedisplayoflivedatainaschematicdrawingofthe
system
The following requirements must be met in order to display live data (of a control-
ler connected) in a schematic drawing of the system:
• A schematic drawing of the system must be created using a drawing program
(e. g. Inkscape or Graphic Works).
• The schematic drawing must be supplied in one of the following formats: *.jpg,
*.gif, *.png, *.bmp, *.tif.
• The RESOL ServiceCenter software must be installed on the computer.
• The FTP access to the DL2 Datalogger must be enabled.
See chap. 12FTPaccessconguration, page 23.
The address and the port of the DL2 Datalogger must be on hand.
See chap. 9.2 Logintervalconguration, page 19.
Uploading a system drawing
In order to upload a system drawing into the Web interface of the DL2 Datalogger,
proceed as follows:
1. Start the RESOL ServiceCenter software.
2. In the main menu Window, select the submenu Show view Î VBus
®
logging.
3. Click the Designer tab.
4. Right-click the empty graphic (white square) and select Edit.
5. Select Use background image and click the [...] button to the right.
6. Select the drawing prepared as a background image and click Open.
7. Click OK.
8. Click Connect.
9. Select the DL2 Datalogger and enter the remote access password.
10. Right-click the system drawing and select Î Add VBus
®
eld.
9.4 Networkconguration
The network conguration determines where the DL2 Datalogger obtains its IP
information.
There are 2 different settings possible for the network conguration:
• Dynamic (DHCP): The IP information is automatically assigned to the DL2
Datalogger by the DHCP server.
• Static: The user manually assigns date and time information to the DL2 Datalogger.
Note
Consult the system administrator before changing the factory settings!
In order to congure the network conguration, proceed as follows:
1. In the main menu DeviceCong, select the submenu Network.
2. In the LANcongurationmodedropdown menu, select the desired value.
3. Click Saveconguration.
The message Congurationsavedsuccessfully! appears.
The menu item IP Recovery can be used to automatically retrieve a new IP ad-
dress for the DL2 in the case that the previous one is lost. In order to congure the
automatic IP address conguration, proceed as follows:
1. In the IP Recovery menu item, select Ye s .
2. Click Saveconguration.
The message Congurationsavedsuccessfully! appears.
3. Restart the Datalogger
9.5 Datadisplayconguration
Example of a live data display
The DL2 Datalogger displays live data of the controller connected. In the tabular
overview, the data are refreshed automatically every 10 seconds.