Resol DL2 - 6 Accessing the DL2 Datalogger with the RPT Parameterisation Tool Via Vbus.net; 7 Web Interface; Menu

11
InstallationData export / CongurationEliminating errors Conguration Web-Interface Indications
en

6 Accessing the DL2 Datalogger with the RPT Param-
eterisation Tool via VBus.net
To use RPT, the VBus access over local network has to be enabled.
In order to activate the VBus access, proceed as follows:
1. In the main menu DeviceCong, select the submenu Remote Access.
2. On the VBus access over local network tab, in the dropdown menu Local
network access enabled? select Yes.
3. On the Remote access over Internet tab, in the dropdown menu Use
VBus.net for remote access? select Yes.
With a VBus.net account you can easily use RPT in order to parameterise the
controller:
1. In the VBus.net menu My Devices, click on Edit.
2. On the General settings page, tick the option Allow parameterization
using the via address and the RESOL Parameterization Tool (RPT).
3. Enter the Via tag from the VBus.net menu item General settings into the
RPT eld URL/IP.
4. Enter the password into the Password eld.
5. Click on Connect.
7 Web interface
The Web interface is integrated in the DL2 Datalogger and can be run on an Inter-
net browser.
The Web interface has the following functions:
• Display the status of the DL2 Datalogger.
• Congure the DL2 Datalogger.
• Display real-time data in a table.
• Export, customise and erase data.
7.1 Menu
The menu column with all main menus and their corresponding submenus are indi-
cated on the left-hand side of the Web interface.
Note
The menu structure may change in later rmware versions.