Resol DL2 - Configuring the Remote Access

17
InstallationData export / CongurationEliminating errors Conguration Web-Interface Indications
en
4. In order to start the update, click Install update.
When the update has been installed, the device restarts. It is necessary to log in
again.
If no update is to be carried out, click Discard update.
8.9 Conguringtheremoteaccess
ATTENTION!
Third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
DL2 Datalogger is to be accessed via the RESOL RPT Parameterisation Tool.
Note
For older controller models the RESOL ServiceCenter Software is avail-
able!
In order to change the remote access password, proceed as follows:
1. In the main menu DeviceCong, select the submenu Remote Access.
2. On the Access VBus over local network tab, tick the Change password
checkbox.
3. Enter the current password into the Current password input eld.
The factory setting for the remote access password is vbus.
4. Enter the new password into the New password input eld.
5. Enter the new password into the Repeat new password input eld.
6. Click Saveconguration.
The message Congurationsavedsuccessfully! appears.