Resol DL2 - Operating Control LED; Data Memory Progress Bar; Reset Button; LAN Connector

InstallationData export / CongurationEliminating errors Conguration Web-Interface
9
Indications
en
4.1 Operating control LED

The operating control LED  indicates the operating status of the DL2 Datalogger
by issuing ashing signals.
LEDashingcodes
Colour Permanent Flashing
Green • The device is ready for
operation
• VBus.net connection or
option deactivated
• The device is ready for operation
• No connection to VBus.net
Orange • The device is ready for
operation
• No LAN connection
available
• A rmware update is being run
• Data are being copied onto the SD card
Orange/
Green
- • The device is booting
Off • No power supply
4.2 Data memory progress bar

The data memory progress bar  indicates the currently occupied memory capac-
ity of the DL2 Datalogger.
The data memory progress bar is divided into 10 segments. Each segment repre-
sents 10 % of the memory capacity.
Data memory progress bar
LED segment
permanently on • The memory capacity of this segment is fully occupied.
ashing • The memory capacity of this segment is partly occupied.
• VBus
®
connection okay.
4.3 Reset button

The reset button  is integrated in the operating control LED. By means of the
reset button, data logged can be deleted and the DL2 Datalogger conguration can
be reset to the factory settings.
See chap. 7.4 Erasing logged data, page 13.
Note
After a reset, the device has to be added to VBus.net again.
4.4 LAN connector

The integrated LAN connector  is located on the right-hand side of the device.
The LAN connector supports transfer rates of up to 100 MBits per second.