Resol DL2 - Data; Erasing Logged Data; Displaying Firmware Versions; Displaying the Device Date; Time

13
InstallationData export / CongurationEliminating errors Conguration Web-Interface Indications
en
7.3 Data
In the live data screen, the values of the controller connected are displayed and re-
freshed automatically every 10 seconds. The representation and the measurement
units of the live data can be customised.
Live data of a controller connected can be displayed as follows:
• In a tabular overview
• In a schematic drawing of the solar system
7.4 Erasing logged data
Logged data can be erased over the Web interface. The conguration is not affected.
In order to erase logged data, proceed as follows:
1. In the main menu Data, select the submenu Erase.
2. Click the Erase button.
The message Data erased successfully! appears.
7.5 Displayingrmwareversions
In order to display statistics about the rmware updates run, proceed as follows:
Î In the main menu About, select the submenu General.
The following information is displayed:
• Firmware update versions
• Firmware update dates
See chap. 16.1 Possibleexportleformats, page 26.
7.6 Displaying the Device Date / Time
In order to display the device date and the device time, proceed as follows:
Î In the main menu Status, select the submenu General.
The following information is displayed:
• Current date and time settings of the DL2
• Device uptime since the last reset
See chap. 8.6 Conguringdateandtimeinformation, page 15.
7.7 Displayingnetworkconguration
In order to display the network conguration, proceed as follows:
Î In the main menu Status, select the submenu Network.
The following information is displayed:
• LAN IP address
• LAN network / netmask
• Gateway
• Nameserver 1
• Nameserver 2
See chap. 9.4 Networkconguration, page 20.
7.8 Displaying data communication
In order to display statistics about the data exchange between the DL2 Datalogger
and the controllers connected, proceed as follows:
Î In the main menu Status, select the submenu General
The following information is displayed:
• Total received bytes count since last reset
• Total received packet count since last reset
• Total unique packet count since last reset
7.9 Displaying the memory capacity
In order to display the memory capacity, proceed as follows:
Î In the main menu Status, select the submenu General.
The following information is displayed:
• Capacity in use
• Capacity free
• Remaining days
Note
The log interval determines the Remaining days. Depending on the ad-
justment selected, the logging either stops when the capacity is fully used
or the oldest data are overwritten.
See chap. 9.2 Logintervalconguration, page 19.