31
8.7 Flight mode (optional)
i
WARNING: When boarding a flight or entering an area where RF transmitters are prohibited, wire-
less functionality must be deactivated.
Your ReSound LiNX 3D hearing aid allows you to control it from your smart phone or ReSound Remote
Control. However, in some areas you are requested to turn o wireless communication.
Follow these steps to turn o wireless mode:
1. For each hearing aid, open and close (open-close, open-close, open-close) the battery door three
times within a 10-second period.
2. Double-dings for ten seconds ( etc.) indicate that your hearing aid is in Flight mode.
Follow these steps to activate wireless mode:
1. For each hearing aid, open and close the battery door once.
2. Your hearing aids are in wireless mode after 10 seconds.
i
NOTE: Both hearing aids must be set in Flight mode - even with synchronization enabled.
NOTE: It is important to wait an additional 15 seconds after wireless function resumes before
opening and closing the battery door again for any reason. Flight mode will resume if you open
and close the battery door during this 15-second window.
NOTE: Flight mode must be activated by clinician in order to be controlled.
400618011US-17.01-Rev.A.indd 31 25-01-2017 09:59:14
To Next Page
Loading...
