RAMP® System Operation
Operator’s Manual, RAMP
®
Reader 29
Enter the User ID using the keypad or optional barcode wand. A maximum of 20 alphanumeric
characters can be input for the User ID. When finished editing, press [Enter] to store the displayed
User ID. To accept the ID without editing, press [Options] or [Enter] with nothing typed. The screen
advances to the EDIT P.I.N. prompt.
Type in new P.I.N. and press [Enter] to accept. To accept the P.I.N. without editing, press [Options]
or [Enter] with nothing typed. The screen returns to SYSTEM Menu. On entering a P.I.N., the
Reader checks for a duplicate P.I.N. in memory while displaying the following screen:
If the entered P.I.N. does not match any in memory, P.I.N. IS OKAY is displayed and the Reader
returns to the SYSTEM Menu.
If an identical P.I.N. is already in memory, the following screen is displayed:
The Reader then displays the EDIT P.I.N. screen as shown above.
NOTE: When operating on battery power, if a new/revised User ID is not entered within 30
seconds, the screen advances to the EDIT P.I.N. prompt as displayed above.
Press [Enter] to accept the information entered.
To cancel editing, press [Options] repeatedly to remove all characters previously entered and return
to the SYSTEM menu.
2.6.6 Print Settings
The Print Settings allow automatic printing of results after each test, and the ability to include two
additional lines of information with each printout, such as institution and/or department name.
From the SYSTEM Menu, press [▲] or [▼] until 5. PRINT SETTINGS is displayed. Press [Enter] to
select this option, the PRINT SETTINGS menu is displayed.
2.6.6.1 Print options after assay completion
To change the print options, select 1. PRINT OPTION and press [Enter].
> 1. PRINT OPTION
2. ADD INFORMATION
ERROR:DUPLICATE PIN!
INPUT DIFFERENT PIN
CHECKING P.I.N.
PLEASE WAIT...
EDIT P.I.N.: 00000
_ ***************
To Next Page
Loading...