RAMP® System Operation
Operator’s Manual, RAMP
®
Reader 22
If there are no results stored in the Reader’s memory, the following is displayed with a long beep:
Press any key to return to the SELECT RESULT TYPE Menu.
2.5.2 View Results
To review results from previous samples on screen without outputting to a computer or printer,
perform the following steps.
From the RUN/OPTIONS Menu select Options, then press [▲] or [▼] and select 2. VIEW RESULTS.
Press [Enter], the screen displays the following Menu:
The three types of results available to select are:
1. Sample Results 2. LQC Results 3. IQC Results
Press [▲] or [▼] until the desired result type is displayed. Press [Enter] to select the specified option.
Pressing [Options] will switch the display back to the OPTIONS Menu.
Pressing [Enter] at 1. SAMPLE RESULTS displays the most recent sample result, for example:
Pressing [Enter] at 2. LQC RESULTS displays the most recent LQC result. Pressing [Enter] at 3. IQC
RESULTS displays the most recent IQC result.
If there are no sample results stored in the memory, the following message is displayed accompanied
by a long beep:
The same sequence of steps applies to viewing SAMPLE, LQC and IQC results. The following
illustrates the steps using a SAMPLE result.
To view a SAMPLE result, select it using [▲] or [▼] and press [Enter].
ID: Patient
TnI 0.40 ng/mL
NO TEST RESULTS IN
MEMORY! PUSH A KEY.
SAMPLE RESULT #13
ID: Patient
SELECT RESULT TYPE:
1. SAMPLE RESULTS
NO TEST RESULTS IN
MEMORY! PUSH A KEY
To Next Page
Loading...