Table of Contents
1 Notes on the manual ............................................................................................................................. 6
1.1 Explanation of signs and symbols ..................................................................................................... 6
1.2 Disclaimer .......................................................................................................................................... 6
1.3 Copyright............................................................................................................................................ 6
2 Safety ...................................................................................................................................................... 7
2.1 Explanations of the Safety Instructions ............................................................................................. 8
2.2 General Safety Instructions ............................................................................................................... 9
2.3 Repairs ............................................................................................................................................. 10
2.4 Intended use of the device............................................................................................................... 11
2.5 Improper use .................................................................................................................................... 11
2.6 Confirmation Form for the Managing Operator................................................................................ 12
3 Technical Data ..................................................................................................................................... 13
3.1 Protective Equipment ....................................................................................................................... 13
3.2 Degree of Protection ........................................................................................................................ 13
3.3 Emissions......................................................................................................................................... 13
3.4 Electromagnetic Compatibility (EMC) .............................................................................................. 14
3.5 Rated Power .................................................................................................................................... 14
3.6 Motor Rotation Speed ...................................................................................................................... 14
3.7 Dimensions and Weight ................................................................................................................... 14
3.8 Required Floor Space ...................................................................................................................... 14
3.9 Receptacle Volume .......................................................................................................................... 15
3.10 Feed Grain Size ............................................................................................................................... 15
4 Packaging, Transport and Installation .............................................................................................. 16
4.1 Packaging ........................................................................................................................................ 16
4.2 Transport.......................................................................................................................................... 16
4.3 Temperature Fluctuations and Condensation ................................................................................. 17
4.4 Conditions for the Installation Site ................................................................................................... 17
4.5 Electrical Connection ....................................................................................................................... 18
4.6 Type Plate Description ..................................................................................................................... 19
5 First Commissioning ........................................................................................................................... 20
6 Operating the Device .......................................................................................................................... 21
6.1 Principle of Operation ...................................................................................................................... 22
6.2 Views of the device .......................................................................................................................... 23
6.2.1 Front ............................................................................................................................................. 23
6.2.2 Back ............................................................................................................................................. 24
6.3 Switching On / Off ............................................................................................................................ 25
6.4 Opening and Closing of the Device ................................................................................................. 25
6.4.1 Opening ....................................................................................................................................... 25
6.4.2 Closing ......................................................................................................................................... 25
6.5 Inserting the Grinding Container ...................................................................................................... 26
6.6 Inserting the Knive Insert ................................................................................................................. 27
6.7 Filling the Grinding Container .......................................................................................................... 28
6.7.1 Filling within the Device ............................................................................................................... 28
6.7.2 Filling outside the Device ............................................................................................................. 28
6.8 Closing the Grinding Container........................................................................................................ 29
7 Controlling the Device ........................................................................................................................ 31
7.1 Operating Controls, Displays and Functions ................................................................................... 31
7.2 Operating Modes and Navigation .................................................................................................... 33
7.2.1 Navigation between Operating Modes ........................................................................................ 33
7.3 Grinding Parameters ........................................................................................................................ 33
7.3.1 Adjustable Parameters ................................................................................................................ 33
7.3.2 Activatable or Deactivatable Parameters .................................................................................... 35
To Next Page
Loading...
