Retsch GM 200 - Editing Saved Programmes; Saving and Deleting Programmes

Controlling the Device
39
7.5.2 Edit a Programme
Fig. 14: Editing a programme
 Press the button (B3.4) to edit the programme.
 Enter the desired grinding parameters.
The process can be cancelled by pressing the button (B1.6). All settings are discarded.
7.5.3 Save a Programme
 Press the button (B3.7) to save the set grinding parameters in the selected programme
memory position.
7.5.4 Delete a Programme
 Press and hold the button (B3.5) for approx. two seconds to delete the grinding
parameters in the selected programme memory position.
After clearing the settings, the speed and the process time of this programme memory position
are set to zero. The interval function is deactivated and the direction of rotation is set to cutting.
B1.6
B1.5
B3.7
B3.5