Error Messages and Information Notes
46
8 Error Messages and Information Notes
8.1 Error Messages
Error messages inform the user about detected device or programme errors. In the event of an
error message, a fault has occurred, in which the operation of the device or the programme is
automatically interrupted. Such faults must be resolved before next startup.
Switch off the main switch and wait for 30 s
before switching on again.
Restart the grinding process, with a smaller
amount of sample material.
If the error persists, contact service.
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Exit the error message via the button.
If the error persists, contact service.
Failure temperature
sensor 1 (motor)
Switch off the main switch and wait for 30 s
before switching on again.
Allow the motor cool down before restart.
If the error persists, contact service.
Failure in safety circuit
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Safety switch defective
(locking)
Exit the error message via the button.
If the error persists, contact service.
Switch off the main switch and wait for 30 s
before switching on again.
If the error persists, contact service.
Exit the error message via the button.
If the error persists, contact service.
To Next Page
Loading...
