Ricoh 2045e - Page 74

Sending Scan File by Scan to Folder
64
5
I If entering a password to log
on is required, press [Manual In-
put] on the right side of the
password field.
The soft keyboard is displayed
for entering a password.
J Enter a password.
K Press [OK].
L Press [Connection Test].
A connection test is performed
to check whether the specified
folder exists.
Note
r To change the path for the
folder that has been entered,
press [Change] located on the
left side of the destination
field. Enter a path for the
folder properly, and then
press [OK].
r Pressing the {Check Modes}
key on the control panel lets
you check the list of selected
destinations.
r The connection test some-
times takes time.
r [Connection Test] can not be
pressed right after [Cancel]
was pressed during the con-
nection test.
r Though the connection test is
succeeded, the machine
sometimes fails in the file
transfer, when the shared
folder lacks writing authori-
ty or when there is no space
in the hard disk.
M To enter more destinations, re-
peat steps A to L.
Note
r To deselect a destination,
press [U Prev.] or [T Next] to
display the destination in the
destination field, and then
press the {Clear/Stop} key.
N Press [OK].
Specifying a folder in the FTP
server
A Press [Enter Destination].
B Press [FTP].
A confirmation message for
changing the protocol appears.
C Press [Yes].
D Press [Manual Input] on the right
side of the server name field.
The soft keyboard is displayed
for entering the server name.
E Enter a server name.
Note
r An IP address can be also en-
tered.
F Press [OK].