Ricoh 816 - Specifying the Original Size When a Paper Tray Is Selected

Placing Originals
14
1
Note
❒ Originals that are 160 mm or less along the feed direction, such as A5K or
5
1
/
2
" × 8
1
/
2
"K, may jam inside the ARDF when you make duplex copies.
❒ Thin originals (64 g/m
2
, 17 lb. or less) that are 310 mm (13") or more along
the feed direction, such as 8
1
/
2
" × 14"L or 8" × 13"L, may jam inside the
ARDF when you make duplex copies.
❒ Straighten curls in the originals before placing them in the ARDF.
❒ To prevent multiple sheets from being fed at once, fan the originals before
placing them in the ARDF.
❒ Set the originals squarely.
Specifying the Original Size When a Paper Tray is Selected
You can select either regular or custom for the size of the original when a paper
tray is selected.
Regular sizes
When placing regular size originals on the exposure glass or in the ARDF, select
the size of the originals from the regular sizes shown on the display.
If you do not specify the original size, the machine will make copies on the paper
size in the tray selected. When copy paper size and original size differ, you need
to specify the original size as follows:
A Select a desired paper tray using {U} or {T}.
B Press the {q} key.
C Select [Regular Size] using {U} or {T}, and then press the {OK} key.