Ricoh Aficio 2035e - Page 115

Programming/Changing LDAP Server
103
4
To enter a port number
A Press [Change] under Port No..
B Enter the port number using
the number keys, and then
press [#].
To set authentication
A Press [Next].
B Press [ON] or [High Security] un-
der Authentication.
Note
❒ [High Security] is not available
with LDAP Version 2.
❒ When [
ON
] or [
High Security
]
is selected, the administrator
account name and password
is required to access the
LDAP server.
❒ When [High Security] is select-
ed, you can use a generic
password unique to the net-
work. If you do this, the serv-
er also requires the same
setting. For details, ask your
network administrator.
To enter the user name and
password
Note
❒ To use the administrator account
for authentication, enter the ac-
count name and password here.
❒ If you leave the user name and
password blank, users will be
prompted for the password eve-
ry time they attempt to connect
to the LDAP server.
A Press [Next].
B Press [
Change
] under User
Name.
C Enter the user name, and then
press [OK].
D Press [Change] under Password.
E Enter the password, and then
press [
OK
].
To test the connection
A Press [Connection Test].
A connection test is carried
out.
B Press [
Exit
].
Note
❒ If the connection test fails,
check your settings, and
then try again.
To set search options
Note
❒ You can search the LDAP server
data using keywords below:
Name, E-mail Address, Fax
Destination, Company Name,
Department Name. You can
specify an additional keyword.
This must be predefined in your
LDAP database.
A Press [Next] twice.
B Press [
Change
] under Attribute.
C Enter the attribute you want to
use for searching e-mail ad-
dresses, and then press [OK].
D Press [Change] under Key Dis-
play.
AdonisC3ver2_GBzenF_FM.book Page 103 Thursday, May 15, 2003 11:21 AM