Troubleshooting
138
5
y
yy
y Removing Punch Waste
Note
❒ While “
Punch Receptacle Full
”
is displayed, you cannot use the
Punch function.
A
AA
A
Open the front cover of the 2 Tray
finisher.
B
BB
B
Pull out the punch waste box, and
then remove punch waste.
C
CC
C
Reinstall the punch waste box.
Note
❒ If you do not, “
Punch Recepta-
cle Full
” is still displayed.
D
DD
D
Close the front cover of the 2 Tray
finisher.
“
Punch Receptacle Full
” disap-
pears.
Note
❒ If the message is still displayed,
reinstall the punch waste box.
❒ The message “
Punch Recepta-
cle Full
” may appear even
when the punch waste box is
not yet full. If this happens, the
position of the punch waste box
(indicated by the arrow as
shown) may be blocked by
punch waste. Remove the
punch waste.
ZDSO010J
ZDSO020J
ZDSO030J
ZHVP010J
AdonisC3ver2_GBzenF_FM.book Page 138 Thursday, May 15, 2003 11:21 AM
To Next Page
Loading...
