Remarks
144
6
Changing the Photoconductor
Unit (PCU)
Only use the photoconductor unit
made specifically for this machine.
Follow the procedure below to
change the unit.
Important
❒ Be sure to unplug the power code
from the outlet before changing
the photoconductor unit.
A Open the front door, duplex unit,
and then transfer unit right cover.
B Push the development unit to the
left, and then pull out the photocon-
ductor unit.
C Remove the harness clamps on the
charge unit and cleaning unit of the
new photoconductor unit.
D Push the development unit to the
left, and then install the new photo-
conductor unit.
Note
❒ If the copy quality is still not satis-
factory after replacing the photo-
conductor unit, contact your
service representative.
AdonisC3ver2_GBzenF_FM.book Page 144 Thursday, May 15, 2003 11:21 AM
To Next Page
Loading...
