Troubleshooting
108
5
Problem Causes Solutions
The main power indicator
continues blinking and
does not turn off when
pressed.
This occurs in the follow-
ing cases:
• The exposure glass cov-
er or the ADF is open.
• The machine is commu-
nicating with external
equipment.
• The hard disk is active.
Close the exposure glass cover or
ADF, and check if the machine is
communicating with a computer.
Original images are print-
ed on the reverse side of
the paper.
You may have loaded the
paper incorrectly.
Load paper correctly. Load paper
into Tray 1-4 with the print side up,
and into the LCT or bypass tray
with the print side down. See p.112
“Orientation-Fixed Paper or Two-
Sided Paper”.
Misfeeds occur frequently. The tray's side guides may
not be locked.
Check the side guides are locked.
p.126 “Changing the Paper Size”.
The tray's end guide may
not be set properly.
Check the end guide is set properly.
See p.126 “Changing the Paper
Size”.
You may have loaded pa-
per of a size not shown on
the paper size selector.
When using paper of a size that can-
not be detected automatically, use
Tray Paper Settings to set the paper
size. See p.55 “Tray Paper Size: Tray
1–4” and p.167 “Copy Paper”.
An error message remains,
even if misfed paper is re-
moved.
When a misfeed message
appears, it remains until
you open and close the cov-
er, as required.
Clear misfed paper, and then open
and close the front cover. See p.116
“x Clearing Misfeeds”.
Cannot print in duplex
mode.
You cannot use paper in
the bypass tray for duplex
printing.
For duplex printing, select Tray 1-4
in copier mode or with the printer
driver.
[1 Sided Copy] is selected for
Paper Type: Tray 1-4.
Select [2 Sided Copy] for Paper Type:
Tray 1-4. See p.56 “Paper Type: Tray
1–4”
You forgot your key opera-
tor code
— Contact your service representative.
AdonisC3ver2_GBzenF_FM.book Page 108 Thursday, May 15, 2003 11:21 AM
To Next Page
Loading...
