Changing the Paper Size
127
5
F
FF
F
Square the paper and load it into
the tray.
Important
❒ Check that the top of the stack is
not higher than the limit mark
inside the tray.
❒ Make sure the paper stack is
flush against the right side
fence.
Note
❒ Fan the paper before loading.
❒ Straighten curled or warped pa-
per before loading.
G
GG
G
After loading, make sure that on
either side, the paper does not
catch (on 1). Push down the paper
stack.
H
HH
H
Lock the side lever.
I
II
I
Adjust the tray size with the pa-
per size selector to the new paper
size.
To adjust the paper size to a size
not indicated on the paper size
selector
A Set the paper size selector to
the p
pp
p mark.
B Press the {
{{
{User Tools/Counter}
}}
}
key.
C Press [System Settings].
D Press [Tray Paper Settings].
E Press [Tray Paper Size: Tray 1],
[Tray Paper Size: Tray 2], [Tray Pa-
per Size: Tray 3] or [Tray Paper
Size: Tray 4].
F Select the required size, and
then press [OK].
HWY040E
ZHWY060E
HWY050E
ZDSY180J
AdonisC3ver2_GBzenF_FM.book Page 127 Thursday, May 15, 2003 11:21 AM
To Next Page
Loading...
