ENERGY SAVER MODES
A265/A267 2-78 SM
2.11.2 ENERGY SAVER MODE
Entering the energy saver mode
The machine enters energy saver mode when one of the following is done.
•
The Energy Saver Key is held down for a second.
•
The energy saver timer runs out after the last job (User Tools - System Settings -
Panel Off Timer: default setting is 60 s).
What happens in energy saver mode
When the machine enters energy saver mode, the fusing lamp drops to a certain
temperature and the operation panel indicators are turned off except for the Energy
Saver LED and the Power LED.
If the CPU receives the image print out command from an application (e. g. to print
incoming fax data or to print data from a PC), the fusing temperature rises to print
the data. However, the operation indicators stay off.
Return to stand-by mode
If one of the following is done, the machine returns to stand-by mode:
•
The Energy Saver Mode key is pressed
•
An original is placed in the ADF
•
The ADF (or platen cover ) is lifted
•
A sheet of paper is placed in the by-pass feed table
The recovery time from energy saver mode is about
3 s
.
Mode
Operation
Switch
Energy
Saver
LED
Fusing Temp.
System
+5V
Energy Saver
Mode
On On
160
°
C
On
To Next Page
Loading...
