Ricoh Aficio 220 - Page 643

BIT SWITCHES
A265/A267 4-44 SM
Communication Switch 06
No FUNCTION COMMENTS
0 Dialing requirements:
Germany
0: Disabled 1: Enabled
1
Dialing requirements: Austria
0: Disabled 1: Enabled
2
Dialing requirements: Norway
0: Disabled 1: Enabled
3
Dialing requirements:
Denmark
0: Disabled 1: Enabled
4
Dialing requirements: France
0: Disabled 1: Enabled
5
Dialing requirements:
Switzerland
0: Disabled 1: Enabled
These switches are automatically set to the
settings required by each country after the
country code (System Switch 0F) is programmed.
6
Not used Do not change the setting.
7
Carrier drop display
0: Disabled 1: Enabled
This is an European PTT requirement.
This bit is available only for the European models.
Communication Switch 07
No FUNCTION COMMENTS
0
Fallback from G4 to G3 if the
other terminal is not a G4
terminal
0: Disabled
1: Enabled
Also see system switch 0A bit 7.
Refer to the ISDN G4 option service manual (G4
Internal Switches 17, 18, 1A, 1B, and 1C) for the
CPS code set (Cause Value set) that determines
G4 to G3 fallback.
1
Not used Do not change the setting.
2
Not used Do not change the setting.
3 Fallback from G4 to G3
reflected in programmed
Quick/Speed dials
0: Fallback enabled
1: Always start with G4
0: If a communication falls back from G4 to G3,
the machine will always start transmission with
G3 from the next communication.
1: The machine will always start to transmit with
G4.
4
Fallback from G4 to G3 when
G4 communication fails on the
ISDN B-channel
0: Fallback disabled
1: Fallback enabled
1: Enable this switch only when G4
communication errors occur because the
exchanger connects G4 calls to the PSTN.
This problem occurs with some types of
exchanger.
5
Not used Do not change the setting.
6
Not used Do not change the setting.
7
Not used Do not change the setting.