System Settings
46
2
❖ IPv6 Stateless Setting
Specify IPv6 Stateless Setting.
The default setting is Active.
❖ DNS Configuration
Make settings for the DNS server.
The default setting is Specify.
When you select [Specify], enter the DNS server IPv4 address as
"xxx.xxx.xxx.xxx"("x" indicates a number).
The default settings of DNS server 1-2 are 000.000.000.000.
❖ DDNS Configuration
Specify the DDNS settings.
The default setting is Active.
❖ Domain Name
Specify the domain name.
The default setting is Specify.
❖ WINS Configuration
Specify the WINS server settings.
The default setting is Off.
If [On] is selected, enter WINS server IPv4 address as "xxx.xxx.xxx.xxx. ("x" in-
dicates a number)"
The default settings of WINS server 1-2 are 000.000.000.000.
If DHCP is in use, specify the [Scope ID].
Enter a [Scope ID] using up to 31 characters.
❖ Effective Protocol
Selects the protocol to use in the network.
The default setting for IPv4 is Active
The default setting for IPv6" is Inactive.
The default setting for NetWare is Active.
The default setting for SMB is Active.
The default setting for AppleTalk is Active.
❖ NCP Delivery Protocol
Select the protocol for NCP delivery.
The default setting is TCP/IP Priority.
If you select "IPX Only" or "TCP/IP Only", you cannot switch the protocol
even if you cannot connect with it.
If "NetWare" in [Effective Protocol] is set to "Invalid", you can only use TCP/IP.
❖ NW Frame Type
Select the frame type when you use NetWare.
The default setting is Auto Select.
To Next Page
Loading...
Need help?
General
