Specifying E-mail Destinations
25
1
K Press [Search].
Destinations that match the search conditions are displayed.
L Press the {U} or {T} key to select the destination, and then press the {V}
key.
The check box on the left side of the selected destination is selected.
M Press the {OK} key.
Note
❒ Up to 100 destinations can be displayed as search results.
❒ If an e-mail address returned by the LDAP server is too long, it will be im-
possible to specify it as the destination. For details about the number of
characters that can be specified, see "E-mail".
❒ You can register multiple e-mail addresses in individual LDAP server ac-
counts. However, only one e-mail address will be displayed as the search
result. Usually, the address that was registered first on the LDAP server is
the address that is displayed.
❒ You can select criteria from the following list:
• [Include]: The names which contain an entered character or characters are
targeted.
Example) To find "ABC", enter "A", "B" or "C".
• [Exclude]: The names which do not contain an entered character or charac-
ters are targeted.
Example) To find "ABC", enter "D".
• [First Word]: The names which start with the entered character or characters
are targeted.
Example) To find "ABC", enter "A".
To Next Page
Loading...
Need help?
General
