When Using as a TWAIN Scanner
89
4
Preparation for Using the Network TWAIN Scanner
This section explains the preparation and settings for using the network TWAIN
scanner function.
Important
❒ To use the network TWAIN scanner, a TWAIN-compliant application, such
as DeskTopBinder, must be installed on the client computer. DeskTopBinder
Lite is on the supplied CD-ROM. For details about installing DeskTopBinder
Lite, see “Installing DeskTopBinder Lite from Provided CD-ROM”.
A Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or wireless LAN
(IEEE 802.11b).
B Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask.
•In [Effective Protocol], enable [IPv4].
C Install the TWAIN driver on a client computer.
For details about installing the TWAIN driver, see “Installing the TWAIN
Driver from Provided CD-ROM”.
Note
❒ To connect the machine to the network using a wireless LAN (IEEE 802.11b),
an extended wireless LAN board is required respectively. For details, see
Network Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For more information about network settings, see General Settings
Guide.
❒ For more information about [System Settings], see General Settings Guide.
Reference
p.90 “Installing TWAIN Driver from Provided CD-ROM”
p.75 “Installing DeskTopBinder Lite from Provided CD-ROM”
To Next Page
Loading...
Need help?
General
