Sending Scan Files by Scan to Folder
48
2
Basic Procedure for Sending by Scan to Folder
This section describes the basic operation for sending scan files by Scan to Folder.
A Make sure that no previous settings remain.
If a previous setting remains, press the {Clear Modes} key.
B If the Network Delivery Scanner or E-mail screen is displayed, press []
key to switch to the Scan to Folder screen.
C Place originals.
D If necessary, select the original type.
For details, see "Selecting Original Type".
E If necessary, specify the scanning density.
For details, see "Adjusting Image Density".
F Select a destination
You can specify multiple destinations.
For details, see "Specifying Scan to Folder Destinations".
G If necessary, press [Options] to specify the resolution and orientation of the
originals.
For details, see "Specifying Send Options".
H Press the {Start} key.
Scanning starts.
You must press the {q} key to send scan files that are scanned from the ex-
posure glass.
Scan files that are scanned from the ADF/ARDF are sent immediately.
To Next Page
Loading...
