Sending Scan Files by Scan to Folder
64
2
F Enter the password, and then press the {OK} key.
G Enter the path to the destination folder, and then press the {OK} key.
The following is an example of a path where the sub folder name is “lib” and
the folder name is “user”: user\lib.
A destination confirmation screen appears.
H Press [Com.Test].
A connection test starts.
I The test result appears. Press [Exit].
J Press the {OK} key.
Note
❒ If you change the protocol after entering the path name, user name, or pass-
word, a confirmation message appears.
❒ The connection test may take time.
❒ You can register the destination path in the machine’s address book. For
details, see “Registering the Path to the Selected Destination in the Address
Book”.
To Next Page
Loading...
