Specifying Scan to Folder Destinations
69
2
F A login screen appears if authentication is required. Enter a user name and
password, and then press the {OK} key.
G Select a context or volume that contains the required destination folder,
and then press the {OK} key.
A list of destination folders appears.
H Select the destination folder, and then press [Apply].
I The path to the selected folder is displayed. Check the path is correct, and
then press the {OK} key.
J The destination is displayed. Check the destination is correct, and then press
the {OK} key.
Note
❒ If you change the protocol after entering the path name, user name, or pass-
word, a confirmation message appears.
❒ Only folders that you have the read privileges for are displayed.
To Next Page
Loading...
