Facsimile Features
158
4
I Enter the SEP Code.
To change the SEP Code, press [Clear] or the {Clear/Stop} key, and then try
again. To change the box name, press [Box Name], and then repeat the proce-
dure from step
H
.
J Press [Password].
If you do not want to program a password, proceed to step
M
.
K Enter a password, and then press [OK].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
L Re-enter the password, and then press [OK].
To change the password after pressing [OK], press [Change] and repeat steps
K
and
L
, or press [Cancel] and repeat from step
J
.
M Press [OK].
N Press [Exit].
O Press the {User Tools/Counter} key.
Note
❒ You can edit boxes in the same way you program them. However, boxes
that are being used cannot be edited.
❒ If a destination in the destination list is deleted after being registered, de-
livery is not performed and the settings of the delivery destination are also
deleted. Also, when a delivery destination is changed, a document is sent
to the changed destination. If there is no destination of the specified type,
you can set which destination to be used as an alternative destination. See
"Parameter Settings" (switch 32, bit 0).
Reference
p.131 “Parameter Settings”
"Information Boxes", Facsimile Reference
"Entering Text", About This Machine
To Next Page
Loading...
