Box Settings
161
4
E Check that [Program / Change] is selected.
F Select the box to program.
When programming a new box, press [*Not Programmed].
To change a box already programmed, press it, and then proceed to step
I
.
G Press [Transfer Box].
H Enter a Box name, and then press [OK].
I Enter a SUB Code.
To change the SUB Code, press [Clear] or the {Clear/Stop} key, and then try
again. To change Box name, press [Box Name], and then repeat from step
H
.
J Specify the condition of registration.
To program End Receivers, see "Programming End Receivers".
To program a password, see "Programming a password".
K Press [OK].
L Press [Exit].
To Next Page
Loading...
