Box Settings
175
4
E Select a box to program.
When programming a new box, press [Not Programmed].
To change a box already programmed, press it and proceed to step
H
.
F Press [Personal Box].
G Enter a box name, and then press [OK].
H Enter a SUB Code.
To change the SUB Code, press [Clear] or the {Clear/Stop} key, and then try
again. To change a Box name, press [Box Name], and then repeat from step
G
.
I Specify the settings you require.
If you do not want to program a password or receiver, proceed to step
P
.
J Press [Password].
To Next Page
Loading...
