Box Settings
179
4
E Select the box to program.
When programming a new box, press [Not Programmed].
To change a box already programmed, press it, and then proceed to step
H
. If
a password is programmed, enter the password, press [OK], and then proceed
to step
H
.
F Press [Information Box].
G Enter a box name, and then press [OK].
H Enter the SEP Code.
To change the SEP Code, press [Clear] or the {Clear/Stop} key, and then try
again. To change the box name, press [Box Name], and then repeat the proce-
dure from step
G
.
I Press [Password].
If you do not want to program a password, proceed to step
L
.
To Next Page
Loading...
