Box Settings
183
4
E Select the box to program.
When programming a new box, press [Not Programmed].
To change a box already programmed, press it, and then proceed to step
H
.
F Press [Transfer Box].
G Enter a Box name, and then press [OK].
H Enter a SUB Code.
To change the SUB Code, press [Clear] or the {Clear/Stop} key, and then try
again. To change Box name, press [Box Name], and then repeat from step
G
.
I To Program End Receivers, Select an Receiving Station.
You can store five Receiving Station.
To Next Page
Loading...
