1. Open the bypass tray and set the envelopes print side down, flaps open and pointing away
from the machine. Push the envelopes into the machine until you hear the beep.
2. Align the paper guides to the envelope size.
3. Press [Bypass], and then press the [ ] key.
4. Press [Paper Size].
5. Select the envelope size, and then press [OK] twice.
6. Place the originals, and then press the [Start] key.
• When placing an original on the exposure glass, place the original with the bottom line aligned to
the left scale.
• When placing an original in the ADF, place the original with the bottom line inserted in the ADF.
• Load envelopes with flaps fully open. Otherwise, they might not feed into the machine.
• When loading envelopes in the landscape ( ) orientation, set them so that their flaps are closed,
facing upward, and pointing toward the front of the machine.
Copying from the Bypass Tray
51
To Next Page
Loading...
