Bit Function Default Details
2 Pulling back envelopes 0 You can prevent the banding caused by vibration
of the envelope when its trailing edge passes
through the 1st pressure rollers during printing.
The machine first feeds the envelope until its trailing
edge passes through the 1st pressure roller, pulls it
back to the position to start printing, and then starts
printing.
To use this function, the following requirements
must be met.
(1) Paper tray: Tray 1
(2) Paper size: Envelope
(3) Paper type: Envelope or Inkjet Envelope
This function is available only if the duplex unit is
mounted.
0: Do not pull back envelopes.
1: Pull back envelopes.
3 Not Used --- ---
4 Capping print heads
after printing
0 You can specify whether or not to cap print heads
immediately after printing.
If the capping is not executed immediately, it is
executed nine seconds after printing by the
capping timer.
0: Cap immediately.
1: Do not cap immediately.
5 Periodic sending of
Gratuitous ARP
packets
0 You can specify whether or not to send gratuitous
ARP packets at regular intervals of 60 seconds.
This will not affect the sending of gratuitous ARP
packets when detecting a linked device.
0: Do not send gratuitous ARP packets every 60
seconds.
1: Send gratuitous ARP packets every 60 seconds.
6 Not Used --- ---
7 Not Used --- ---
2. Appendix: SP Mode Tables
28
To Next Page
Loading...
