Action 2
• Clean transport belt.
• Replace TE sensor.
•
Replace Tray 2.
Jam 8 Not Used
Jam 9 Registration Late Jam: Tray 1
Message
Paper Misfeeed
Press the Form Feed button.
Cause
• Paper feed rollers slipped, could not feed paper
•
Paper caught, warped in paper feed path.
Details
After the paper fed from the tray, or when the paper was inverted for duplexing, after
the trailing edge sensor went ON, the registration sensor failed to detect within the
prescribed time.
Action 1
• Press [Form Feed] key on operation panel.
Action 2
• Replace registration sensor 1.
• Replace trailing edge sensor 2.
Jam 10 Registration Late Jam: Tray 2 (PFU)
Message
Paper Misfeeed
Press the Form Feed button.
Cause
• Paper feed rollers slipped, could not feed paper
• Paper caught, warped in paper feed path.
Details
After the paper fed from the tray, or when the paper was inverted for duplexing, after
the trailing edge sensor went ON, the registration sensor failed to detect within the
prescribed time.
Action 1 • Press [Form Feed] key on operation panel.
Action 2
• Replace inverter guide.
• Replace TE sensor.
•
Replace CTL board.
3. Appendix: Troubleshooting Guide
102
To Next Page
Loading...
